TRANSMISSION ASSEMBLY REPLACEMENT/REPAIR - continued

TM 10-3930-673-34

7-4. TRANSMISSION ASSEMBLY REPLACEMENT/REPAIR (CONT)

(3)

Install transmission (3) in vehicle.

WARNING

Use care when installing snap and

retaining rings. Snap and retaining

rings are under spring tension and

can act as projectiles when released

and could cause severe eye injury.

(a)

If removed, install screw (40),

mounting bracket (41), shaft (46),

and retaining rings (45) on

transmission (3).

WARNING

TR00199

Adhesives, solvents, and sealing

compounds can burn easily, can give

off harmful vapors, and are harmful

to skin and clothing. To avoid injury

or death, keep away from open fire

and use in a well-ventilated area. If

adhesive, solvent, or sealing

compound gets on skin or clothing,

wash immediately with soap and

water.

(b)

Apply sealing compound on threads of eight screws (38). Install two brackets (37), eight

lockwashers (39), and screws. Tighten screws to 220 lb-ft (298.3 Nm).

WARNING

Transmission weighs approximately 950 lbs (431 kg). Attach suitable lifting device prior

to removal or installation to prevent possible injury to personnel.

(c)

Attach a hoist with slings to transmission (3). Place slings under input yoke and output yokes.

Secure slings together.

(d)

Lift transmission (3) into vehicle. Ensure that hoses and other obstructions are clear of

transmission during installation. Lower transmission until its mounts are resting on

transmission supports.

7-36