TRANSMISSION ASSEMBLY REPLACEMENT/REPAIR - continued

TM 10-3930-673-34

(r)

Install weld gear (89) on shaft

assembly (77). Turn weld gear so it

meshes with clutch plates (85) and

separator plates (86). Push weld

gear until it bottoms out. Weld gear

splines must be in full position with

internal teeth of all clutch plates.

(s)

Remove weld gear (89).

WARNING

Use care when installing snap and

retaining rings. Snap and retaining

TR00226

rings are under spring tension and

can act as projectiles when released

and could cause severe eye injury.

(t)

Press one bearing (90) onto shaft assembly (77) until it is tight against snap ring (79).

(u)

Install appropriate pair of alignment bars between weld gear (89) and piston (95), as required,

to hold weld gear off piston. Use either narrow or wide side of bars to ensure that weld gear is

held off piston 1/4 in. (6.4 mm) and at the same time engages all clutch plates.

(v)

Install weld gear (89) on shaft assembly (77).

(w) Press one bearing (90) onto shaft assembly (77) and into weld gear (89). Remove alignment

bars to seat bearing and weld gear.

(x)

Install snap ring (88) onto shaft assembly (77).

(y)

Press bearing (87) onto shaft

assembly (77).

TR00212

7-31