TRANSMISSION ASSEMBLY REPLACEMENT/REPAIR - continued

TM 10-3930-673-34

7-4. TRANSMISSION ASSEMBLY REPLACEMENT/REPAIR (CONT)

TR00225

(j)

Install appropriate pair of alignment bars between weld gear (80) and piston (95) as required

to hold weld gear off piston. Use either narrow or wide side of bars to ensure that weld gear is

held off piston 1/8 in. (3.2 mm) and at the same time engages all clutch plates (86).

(k)

If removed, install snap ring (82) in weld gear (80).

(l)

Install weld gear (80) on shaft assembly (77).

(m) Use a bearing driver to press bearing (81) onto shaft assembly (77) and into weld gear (80).

Remove alignment bars to seat bearing and weld gear.

(n)

Install snap ring (79). Ensure that snap ring is fully in groove of shaft assembly (77).

(o)

Use a bearing driver to press

bearing (78) onto shaft

assembly (77).

(p)

Apply grease to three seal rings (76)

and install on shaft assembly (77).

(q)

Turn shaft assembly (77) over and

repeat Steps (a) through (h).

TR00208

7-30