TORQUE CONVERTER REPLACEMENT/REPAIR - continued

TM 10-3930-673-34

7-3. TORQUE CONVERTER REPLACEMENT/REPAIR (CONT)

(a)

Install preformed packing (44) at

base of impeller hub (41).

(b)

Install seal ring (45) on impeller

hub (41).

(c)

Install impeller hub (41), eight

screws (42), and washers (43) on

impeller (18). Tighten screws to

25 lb-ft (33.9 Nm).

(d)

Install inner thrust washer (40),

needle thrust bearing (39), and

outer thrust washer (38) on impeller

hub (41).

TR00191

(2)

Assemble parts (33 through 37),

install stator (32), and parts (29, 30,

and 31).

(a)

Install outer race (37), sprag clutch (36),

and inner race (35). Clutch flange should

be toward front of converter as shown.

Stator will freewheel counterclockwise

viewed from output end.

(b)

Install sprag clutch (36) with flanged

edge of cage toward side of stator (32)

marked "FRONT" or the letter "F." The

stator will free-wheel counterclockwise

when viewed from output side.

WARNING

Use care when installing snap and retaining rings. Snap and retaining rings are under

spring tension and can act as projectiles when released and could cause severe eye

injury.

(c)

Install two clutch retainers (34) and two retaining rings (33).

(d)

Install stator (32) in impeller (18) so that the word "FRONT" faces away from impeller.

(e)

Install inner thrust washer (31), needle thrust bearing (30), and outer thrust washer (29) on

impeller (18).

7-6