CONNECTING RODS AND BEARINGS REPLACEMENT - continued

TM 10-3930-673-34

3-17. CONNECTING RODS AND BEARINGS REPLACEMENT (CONT)

NOTE

Do not use connecting rod screws.

(3)

Remove screws (3), bearing cap (1),

and rod bearings (4) from connecting

rod (5). Discard rod bearings and

screws.

(4)

Remove piston (2) and connecting

rod (5) as an assembly by pushing

out through top of cylinder block.

(5)

Remove connecting rod (5) from

piston (2).

TR01630

WARNING

Use care when removing snap and

retaining rings. Snap and retaining

rings are under spring tension and

can act as projectiles when released

and could cause severe eye injury.

(a)

Remove two retaining rings (6) from

piston (2).

TR01631

(b)

Remove piston pin (7) and separate

piston (2) from connecting rod (5).

TR01632

3-112