FLYWHEEL HOUSING AND COVER REPLACEMENT/REPAIR - continued

TM 10-3930-673-34

f. Installation.

(1)

If removed, install two ring

dowels (7) in flywheel housing (1).

Drive two ring dowels (7) into cylinder

block until they are against bottom of

bore.

(2)

Clean and dry rear crankshaft

sealing surface.

Clean and dry rear crankshaft sealing

TR01232

surface with clean lint-free rags.

CAUTION

The oil seal sealing surface on the

crankshaft must be clean to help

prevent seal leaks.

(3)

Install gasket (6) and rear cover (3).

(a)

Install gasket (6) and rear cover (3)

onto cylinder block.

(b)

Loosely install six screws (5).

(4)

Align rear cover (3) to crankshaft (B)

using seal kit installation and

TR01233

alignment tool.

(a)

Place installation and alignment

tool supplied with oil seal kit over the crankshaft (B) and into the rear cover (3). This aligns

the cover to the crankshaft.

(b)

Align rear cover (3) with both sides of the cylinder block oil pan rail until surfaces are flush.

Tighten six screws (5) to 7 lb-ft (9.49 Nm).

3-101