LOW TRANSMISSION OIL PRESSURE FROM TORQUE CONVERTER - continued

TM 10-3930-673-34

WARNING

Use care when removing snap and retaining rings. Snap and retaining rings are under spring tension and can act as projectiles

when released, and could cause severe eye injury.

Compressed air used for cleaning purposes will not exceed 30 psi. Use only with effective chip guarding and personal protective

equipment (goggles/shield, gloves, and so forth).

Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing.

To avoid injury or death, keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound

gets on skin or clothing, wash immediately with soap and water.

CAUTION

Wipe area clean around all hydraulic connections to be opened during removal. Cap oil lines and plug holes after removing lines.

Contamination of the hydraulic system could result in premature failure.

VISUAL INSPECTION

(1) Remove torque converter from

transmission housing (Para 7-3).

(2) Disassemble torque converter.

(3) Visually inspect the turbine and

impeller assemblies for signs of

damage and/or wear.

(a) If the assemblies are free from

signs of damage and/or wear, go to

Step 2 of this fault.

(b) If the assemblies show signs of

damage and/or wear, replace the

assemblies as necessary

2-31