Installation - TM-10-3930-673-20-20693

TM 10-3930-673-20-2

(c)

Remove adapter (5), elbow (6), and preformed packings (15 and 16) from cylinder (7). Discard preformed

packings.

(d)

Remove piston rod end (14) from sideshift cylinder (7).

(e)

Remove six pads (15) from piston rod end (14).

b. Installation.

(1)

Install fork sideshift cylinder (7) on carriage (8).

(a)

Install six pads (15) on piston rod end (14).

(b)

Apply sealing compound (Item 29, Appendix C) to threads of sideshift cylinder (7).

(c)

Install piston rod end (14) on sideshift cylinder (7).

(d)

Install two preformed packings (15 and 16) and adapter (5) and elbow (6) in cylinder (7).

(e)

Move sideshift cylinder (7) to left and install piston rod end (14) and cylinder in carriage (8).

(f)

Apply sealing compound (Item 33, Appendix C) on both sides of cams (11).

(g)

Install two plates (13), shims (12), cams (11), screws (10), and locknuts (9) in carriage (8).

(2)

Connect two hoses (1 and 2) on fittings (3 through 6).

(a)

Install hose (2) on adapter (6).

(b)

Install hose (1) on adapter (5).

(c)

Connect hose (2) on quick disconnect (4).

(d)

Connect hose (1) on quick disconnect (3).

(3)

Purge air from fork sideshift cylinders (TM 10-3930-673-10).

(a)

Start engine (TM 10-3930-673-10).

(b)

Cycle fork sideshift function and sideshift forks five times.

(c)

Stop engine and relieve hydraulic pressure by operating frame tilt controls (TM 10-3930-673-10).

(4)

If necessary, bleed hydraulic pumps (Para 18-2).

NOTE

Follow-on Maintenance: Install forks (Para 18-16).

END OF TASK

18-157