 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
CARRIAGE TILT CYLINDER REPAIR - CONTINUED
0307 00
ASSEMBLY - CONTINUED
WARNING
Solvent cleaning compound, MIL-PRF-680 Type III is an environmentally compliant and low toxic mate-
rial. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in well-ven-
tilated areas. Keep away from open flames and other sources of ignition.
6.
Use cleaning solvent and clean rag to clean threads on
rod (2) and nut (8).
4
7.
Slide piston (10) onto rod (2).
8.
Apply loctite on threads of rod (2) and nut (8). Install
nut (8) and washer (9) on rod (2).
6
1
9.
Place rod (2) and piston assembly on suitable supports
6
to prevent damage during assembly.
7
10.
Install two wear rings (6) and one new seal (7) on pis-
ton (10). Position wear rings so that gaps are 180
9
8
degrees apart.
5
CAUTION
3
Use care when installing rod and piston
2
assembly. Keep rod in line with cylinder
10
tube to prevent binding. Failure to follow
409-1391
this precaution will cause part damage.
11.
Lubricate cylinder tube (4) inner diameter, piston (10)
outside diameter and gland (3) outside diameter with
clean hydraulic oil.
12.
Position rod (2) and piston assembly in cylinder tube (4).
NOTE
Tighten gland so that it is flush with end of cylinder tube. Do not overtighten gland.
13.
Tighten gland (3) onto cylinder tube (4).
14.
Install counterbalance valve (1) in cylinder tube (4) as noted during disassembly.
15.
Install carriage tilt cylinder (WP 0184 00).
16.
Operate equipment, check for leaks and proper operation (TM 10-3930-660-10).
END OF WORK PACKAGE
0307 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals