 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
REAR DIFFERENTIAL CARRIER ASSEMBLY MAINTENANCE - CONTINUED
0298 00
ASSEMBLY - CONTINUED
NOTE
Shims are not installed at this time.
7
11.
Temporarily install bevel pinion (26) and bearing cage
28
(27) assembly in differential carrier (7). DO NOT
install shims (28) under bearing cage (27).
12.
Install eight capscrews (25) finger-tight.
25
13.
Fasten yoke nut tool to companion yoke (23). Use
26
yoke nut tool (A) to hold bevel pinion (26) in position
23 22
when nut (21) is tightened.
27
21
14.
Torque nut (21) on bevel pinion (26) to 300 to 400 lb-
29 24
ft (407 to 542 Nm).
409-1286
15.
Remove bar from companion yoke (23).
NOTE
Do not read starting torque. Read only torque value after bevel pinion starts to rotate. Starting torque will
give a false reading.
16.
Attach a torque wrench on bevel pinion nut (21). Rotate bevel pinion (26) and read value indicated on torque wrench.
New pinion bearings should be preloaded between 5 and 45 lb-in. (7 and 61 Nm) of torque. Reused pinion bearings
should be preloaded between 10 and 30 lb-in. (1.12 and 3.38 Nm).
17.
Increase bearing preload by removing bevel pinion (26) from bearing cage (27) and installing a thinner bearing spacer
(33). Repeat steps 10 thru 16.
18.
Decrease bearing preload by removing bevel pinion (26) from bearing cage (27) and installing a thicker bearing spacer
(33). Repeat steps 10 thru 16.
A
409-1290
409-1291
19.
Remove nut (21), washer (22) and companion yoke (23) from bevel pinion (26).
20.
Remove eight capscrews (25).
21.
Remove bevel pinion (26) and bearing cage (27), as an assembly, from differential carrier (7).
0298 00-5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals