 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
TRANSMISSION ASSEMBLY REPAIR - CONTINUED
0289 00
ASSEMBLY - CONTINUED
WARNING
Springs are under tension. Always wear face shield when working on compressed springs. Carefully handle
spring in compressed form. Failure to follow this precaution could cause personal injury.
24.
Place shaft assembly (26) in a press. Install a spring compressor tool.
WARNING
Ensure that retainer ring is secure in groove before spring compressor tool is removed from retainer to pre-
vent springs from flying out. Failure to follow this precaution could cause personal injury.
25.
Press down on spring compressor tool and retainer (40) to allow installation of retainer ring (41). Slowly remove spring
compressor tool.
CAUTION
Carefully handle clutch plates so graphite coating does not flake off. Failure to follow this precaution could
cause equipment damage.
26.
Install six clutch plates (34) and six separator plates
(35) into shaft assembly (26). Begin with a separator
26
plate (35) and then a clutch plate (34). Continue by
44
alternating plates. The last plate must be a clutch plate
40
34,35
(34).
33
NOTE
45
32
The separator plates have external teeth
43
and clutch plates have internal teeth. The
41
plates do not have a right or wrong side for
installation.
42
27.
Install retainer (33) on shaft assembly (26).
28.
Install snap ring (32).
409-1182
0289 00-16
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals