 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
TURBOCHARGER ASSEMBLY REPAIR (152 HP) - CONTINUED
ASSEMBLY
NOTE
Balance marks on shaft, thrust collar and impeller must be aligned to make sure rotating parts of turbo-
charger are properly balanced.
1.
Apply clean lubrication oil to groove on shaft (24).
2
2.
Install new split ring seal (26) onto shaft (24) groove
(B).
28 29
27
3.
Install heat shield (25) onto shaft (24).
4.
Clamp a socket in a vice and place shaft and wheel
(24) nut end in socket.
NOTE
Beveled face of retaining rings must face
27
bearings.
28
24
5.
Install new inner retaining rings (29) into bearing
29
GROOVE
26
housing (2).
409-1078
6.
Apply clean lubrication oil to new bearings (28).
25
7.
Install new bearings (28) into bearing housing (2).
NOTE
Beveled face of retaining rings must face bearings.
8.
Install new outer retaining rings (27) into bearing housing (2).
9.
Install bearing housing (2) onto shaft and wheel (24). Rotate housing (2) while pressing onto shaft (24) to seat bearings
(28).
0281 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals