 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
CRANKSHAFT MAINTENANCE - CONTINUED
0271 00
ASSEMBLY
1.
If a new crankshaft is being installed, a new roll pin (22) must be installed.
CAUTION
Do not heat crankshaft gear longer than 45 minutes. The gear will become permanently distorted if it is
heated for longer than 45 minutes.
Heat crankshaft gear (21) in an oven for 45 minutes at 250oF (121oC).
2.
3.
Wearing insulating gloves, install crankshaft gear (21), with timing mark facing you, onto crankshaft until it is against
the shaft shoulder.
22
21
409-908
409-909
NOTE
Wear seals are used only if seal surfaces were damaged and the surface was machined to allow for seals
installation.
4.
Install new front wear seal (19) over end of crankshaft
14
(14).
5.
Install new rear wear seal (20) over end of crankshaft
(14).
19
20
409-904
0271 00-7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals