Click here to make tpub.com your Home Page

Page Title: INSTALLATION - CONTINUED
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 10-3930-660-24-2
INNER BOOM MAINTENANCE - CONTINUED
0262 00
INSTALLATION - CONTINUED
17.
Using hoist and sling to move inner boom, check for clearance of 0.01 to 0.13 in. (0.25 to 3.30 mm) between inner boom
surface and wear pads. If necessary, add or subtract shims (50, 51, 59 and 60) until clearance is within specification.
CAUTION
To prevent damage to hoses and boom electrical cable, have assistant pull rope attached to boom electrical
cable and hoses at rear of outer boom.
NOTE
Be sure wood block placed between flanges of outer boom and intermediate boom during step 2, is still in
place.
18.
Push inner boom (31) into intermediate boom (11)
2
39
until approximately 4 ft of inner boom (31) extends
from front of intermediate boom (11).
19.
Position hoses (13 thru 15) and boom electrical cable
(25) into shives on top side of hose pulley (39).
20.
Untie rope from anchor (37) at rear of outer boom (2).
37
Tie same rope end of hose pulley support bracket (40).
21.
Using chain, rope or hand winch, attach inner boom
(2) and intermediate boom (11) together.
40
25 13 14
15
22.
Pull inner boom (31) and intermediate boom (11) from
outer boom (2) as an assembly until boom hose pulley
2
11
(39) and rope end are visible through hole near ten-
31
sioner (20).
23.
Untie rope end from hose pulley support bracket (40).
Pull rope, hoses (13 thru 15) and boom electrical cable
(25) through hole near tensioner until free of slack.
CAUTION
Have assistant guide hoses through hole
2
20
near tensioner while installing booms.
24.
Make sure that hoses (13 thru 15) and boom electrical
cable (25) wrap around boom pulley (39) and remain
in proper position.
25.
Push inner boom (31) and intermediate boom (11) into
outer boom (2) as an assembly until outer boom is
approximately 1 ft (0.3 m) from flange of intermediate
409-1408
boom (11).
26.
Remove tape from around boom electrical cable (25) and hoses (13 thru 15). Untie rope end from cable (25).
0262 00-11

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business