 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
TRANSMISSION FRONT COVER ASSEMBLY REPLACEMENT - CONTINUED
0238 00
CLEANING
See Cleaning instructions (WP 0316 00).
INSPECTION
See Inspection instructions (WP 0317 00).
INSTALLATION
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
Ensure that two locator bushings are in position on main case. The locator bushings align front cover assem-
bly.
1.
Position new gasket (7) on main case.
2.
Use a hoist to lift front cover assembly (1) and place it on main case.
NOTE
It may be necessary to rotate input shaft slightly to line up gear teeth in front cover clutch packs.
3.
Install four capscrews (6), three capscrews (5) and capscrews (2 thru 4). Torque capscrews to 50 lb-ft (68 Nm).
4.
Install transmission oil pump (WP 0240 00).
5.
Install torque converter (WP 0236 00).
6.
Install transmission control valve (WP 0239 00).
7.
Install transmission assembly (WP 0237 00).
8.
Operate transmission and check for proper operation (TM 10-3930-660-10).
END OF WORK PACKAGE
0238 00-3/(-4 Blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals