 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
TRANSMISSION ASSEMBLY REPLACEMENT - CONTINUED
0237 00
INSTALLATION - CONTINUED
10.
Apply loctite to threads of four capscrews (33). Install left front transmission mounting bracket (35), four new lock-
washers (34) and four capscrews (33). Torque capscrews to 220 lb-ft (298 Nm).
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
40
29
Weight of transmission is 950 lb (431 kg).
36
11.
With assistance, attach a hoist with slings to transmis-
sion (40). Place slings under input yoke and output
yokes. Secure slings together.
28
12.
Lift transmission (40) into vehicle. Ensure that hoses
35
and other obstructions are clear of transmission during
installation. Lower transmission until its mounts are
resting on transmission supports.
34 33
39
32
38
31
37
30
409-1151a
NOTE
Place a drift and wedge between capscrew and side of rear transmission mount to prevent capscrew from
moving when tightening nut.
13.
Apply loctite to threads of capscrew (36). Install nut (37), rebound washer (38), rubber mount (39) and capscrew in rear
transmission mount. Torque nut to 307 lb-ft (416 Nm).
14.
Apply loctite to threads of two hex head capscrews (29). Install two rubber mounts (32), two rebound washers (31), two
nuts (30) and two hex head capscrews. Torque nuts to 307 lb-ft (416 Nm).
15.
Remove slings from transmission (40).
16.
Connect two leads to neutral safety switch (28).
0237 00-8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals