 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
TRANSMISSION ASSEMBLY REPLACEMENT - CONTINUED
0237 00
REMOVAL - CONTINUED
18.
Disconnect two leads from neutral safety switch (28).
19.
Remove two hex head capscrews (29), two nuts (30), two rebound washers (31) and two rubber mounts (32).
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
40
29
Weight of transmission is approximately
36
950 lb (431 kg).
20.
Use a hoist with slings or other lifting device to sup-
28
port transmission. Place slings under input yoke and
35
output yokes. Secure slings together.
21.
Remove four hex head capscrews (33), four lockwash-
34 33
ers (34) and right front transmission mounting bracket
(35). Discard lockwashers.
39
22.
Place a drift and wedge between capscrew (36) and
32
38
side of rear transmission mount to prevent capscrew
31
37
from moving when removing nut.
30
23.
Remove nut (37), rebound washer (38) and rubber
409-1151a
mount (39) from rear transmission mount.
24.
Use hoist to slowly lift transmission (40) until it clears vehicle frame. Ensure that hoses and other obstructions are clear
of transmission during removal.
0237 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals