 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
FUEL INJECTOR PUMP REPLACEMENT (152 HP) - CONTINUED
0224 00
INSTALLATION - CONTINUED
4.
Install three nuts (28) finger tight on pump mounting
28
studs. Pump must be free to move until timing has
B
been set.
409-1062
5.
Install new lockwasher (26) and nut (25).
21
20
28
29
20
26
25
409-1058
6.
If original pump is being installed, rotate pump to
align scribe marks (B). Then torque three nuts (28) to
18 lb-ft (24 Nm).
7.
If installing a new or rebuilt pump without scribe
mark, rotate pump against direction of drive rotation
to take up backlash in gearing and torque nuts (28) to
18 lb-ft (24 Nm). Then place scribe mark (B) on pump
flange using a hammer and small chisel.
B
409-1065
0224 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals