|
|
TM 10-3930-660-24-2
FUEL INJECTOR PUMP REPLACEMENT (152 HP) - CONTINUED
0224 00
INSTALLATION
1.
Push in TDC pin (22) to verify cylinder no. 1 is at
TDC. If necessary, turn engine crankshaft until TDC
pin can be pushed in fully.
22
409-1059
2.
Place new gasket (29) on pump mounting studs.
NOTE
17
14
16
New and reconditioned fuel injection
18
13
pumps come with driveshafts locked at an
angle which aligns shaft key with keyway
in drive gear. Screw is tightened against
shaft to lock shaft. Do not loosen screw
until instructed to do so below.
3.
Position fuel injection pump (19) on mounting studs,
15
using care to prevent key (30) from dropping into tim-
ing gear housing while aligning key (30) with keyway
in gear.
19
409-1057
0224 00-5
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |