 |
|||
|
|
|||
|
Page Title:
EPA ENGINE STARTER REPLACEMENT (new engine is not supplied with a starter) |
|
||
| ||||||||||
|
|
 10. EPA ENGINE STARTER REPLACEMENT
(new engine is not supplied with a
starter)
REMOVAL
a. Remove all wires from the starter motor and the
starter solenoid from the original engine.
b. Remove the three capscrews securing the starter
motor assembly to the original engine bell
housing. Discard the capscrews.
c. Remove the starter motor assembly from the
original engine bell housing.
INSTALLATION
a. Install the starter to the bell housing on the new
engine.
b. Line up the mounting holes of the starter with the
mounting holes in the bell housing.
c. Secure in place with new capscrews (from the
kit). DO NOT install the lower left side mounting
capscrew at this time. Torque the other two
mounting capscrews to 32 lb-ft (43,4 Nm).
11. EPA ENGINE HARNESS RETROFIT
REPLACEMENT (new engine)
INSTALLATION
2
Note: Install tie wraps as necessary
3
a. Route wiring EPA Engine Harness (1) on new
SM1700
engine block. (Figure 19).
1
b. Connect electrical connector (2) to new fuel shut
Figure 19
off connector (3). (Figure 19).
c. Connect electrical connector (4) to relay (5).
(Figure 20).
5
4
SM1710
Figure 20
0326 00-13
11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals