HYDRAULIC HOSES, LINES AND FITTINGS REPLACEMENT

TM 10-3930-660-24-1

HYDRAULIC HOSES, LINES AND FITTINGS REPLACEMENT

0195 00

THIS WORK PACKAGE COVERS

Removal, Inspection, Installation

INITIAL SETUP

Tools and Special Tools

References - Continued

Tool kit, general mechanic's (Item 39, WP 0324 00)

WP 0172 00

Shop equipment, common no. 1 (Item 20, WP 0324

WP 0173 00

00)

WP 0174 00

Tool kit, machinist's (Item 40, WP 0324 00)

WP 0175 00

Tool outfit, HSTRU (Item 41, WP 0324 00)

WP 0176 00

Materials/Parts

WP 0177 00

Cap and plug set (Item 8, WP 0323 00)

WP 0178 00

Oil, lubricating (Item 30, WP 0323 00)

WP 0180 00

Oil, lubricating (Item 33, WP 0323 00)

WP 0184 00

Strap, tie down (Item 56, WP 0323 00)

WP 0189 00

Tag, marker (Item 57, WP 0323 00)

WP 0199 00

WP 0200 00

References

WP 0032 00

Equipment Condition

WP 0131 00

Vehicle parked on level ground (TM 10-3930-660-

WP 0139 00

10)

WARNING

Do NOT remove hydraulic tank filler cap or disconnect or remove any hydraulic system line or fitting

unless hydraulic system pressure has been relieved. Hydraulic system pressure can be over 3,000 psi

(20685 kPa), even with engine and pump OFF. To relieve pressure, lower all hydraulic attachments to

the ground and shut down engine. Move control levers through all operating positions, then SLOWLY

loosen hydraulic tank filler cap. After maintenance, tighten all connections before applying pressure.

Escaping hydraulic fluid under pressure can penetrate the skin, causing injury or death.

At operating temperature hydraulic oil is hot. Allow hydraulic oil to cool before disconnecting any

hydraulics. Failure to do so could result in injury.

CAUTION

Wipe area clean around all hydraulic connections to be opened during removal. Cap lines and plug openings

after removing lines. Contamination of hydraulic system could result in premature failure.

0195 00-1