 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-1
FORKS REPLACEMENT - CONTINUED
0186 00
INSTALLATION
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
NOTE
Each fork weighs 125 lbs (57 kg). Install forks one at a time.
1.
Attach hoist and sling to fork (1) and raise fork over fork carriage (2). Lower fork straight into fork carriage (2).
2.
Align holes on forks (1) with hole at left-hand side of fork carriage (2).
CAUTION
Use care not to damage finish on fork shaft during installation.
3.
Insert fork shaft (8) through fork carriage (2) and fork holes.
4.
Support fork shaft (8) with hoist and sling. Align end of shaft with hole on left-hand side of fork carriage (2).
5.
Insert fork shaft (8) through fork carriage (2) and fork holes.
6.
Apply loctite to six socket head screws (6).
7.
Install fork shaft cap (7) with six socket head screws
(6).
8.
Secure forks (1) to fork sideshift cylinders (5) with
attaching pins (4).
9.
Using hoist and sling, align left-hand fork (1) with left
notch in fork carriage (2).
10.
Using hoist and sling, position right-hand fork (1) so
attaching pin (4) hole in fork is aligned with access
6
hole in fork carriage.
11.
Secure forks (1) to fork sideshift cylinders (5) with
6
attaching pins (4).
5
7
409-710
0186 00-5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals