 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-1
COUNTERWEIGHT REPLACEMENT - CONTINUED
0145 00
REMOVAL - CONTINUED
1.
Position forklift forks in counterweight pockets (2) and raise forks just enough to release tension from pins (3).
2.
Remove two lockpins (4) and two straight pins (3).
3.
Fasten counterweight (1) to forklift using chain or
cable.
4.
Lift counterweight (1) approximately one in. (25 mm)
and then tilt fork tips up just enough to clear counter-
weight from vehicle frame mounts (5).
5.
Carefully remove counterweight (1) from the vehicle.
3
4
6.
Back lifting forklift away from the vehicle and then
lower counterweight (1) to the ground.
5
2
1
409-562
INSTALLATION
WARNING
Use extreme care when lifting counterweight with a forklift. Never allow forks to tip downward. Always tie
counterweight top mount pin holes to the lifting forklift. Failure to follow this warning may allow counter-
weight to slide forwards off forks resulting in damage to equipment and injury or death to personnel.
CAUTION
When placing forks in counterweight, tips of forks must not protrude past front of counterweight. Protruding
fork tips may damage engine area of vehicle.
NOTE
Weight of counterweight is 3,600 lb (1633 kg). Use a forklift of at least 4,000 lb (1814 kg) capacity for lift-
ing the counterweight.
1.
Position lifting forklift forks in pockets (2) of counterweight (1).
2.
Use a chain or cable to fasten counterweight top mount pin holes to forklift.
0145 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals