 |
|||
|
|
|||
|
Page Title:
STEERING CYLINDER BALL JOINT END CAP ASSEMBLIES REPLACEMENT |
|
||
| ||||||||||
|
|
 TM 10-3930-660-24-1
STEERING CYLINDER BALL JOINT END CAP ASSEMBLIES REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Tools and Special Tools
Personnel Required
Two
Tool kit, general mechanic's (Item 39, WP 0324 00)
Equipment Condition
Shop equipment, common no. 2 (Item 19, WP 0324
Steering cylinder removed (WP 0141 00)
REMOVAL
1.
To remove ball joint end cap assemblies (1) and (2)
2
9
8
from steering cylinder (3), loosen nut (4) and cap-
1
6
screw (5) on clamp (6).
2.
Unscrew ball joint end cap (1) from steering cylinder
(3).
3.
Loosen nut (7) and capscrew (8) on clamp (9).
3
4
5
4.
Unscrew ball joint end cap (2) from steering cylinder
7
409-551
(3).
INSTALLATION
1.
Install ball joint (2) on steering cylinder (3). Screw ball joint (2) onto steering cylinder (3) until it stops.
2.
Tighten nut (7) and capscrew (8) on clamp (9).
3.
Install ball joint end cap (1) on steering cylinder (3).
4.
Pull out rod of steering cylinder (3) until it is fully extended.
5.
Rotate ball joint end cap (1) as required until distance
between grease fittings on ball joints (1) and (2) is 26-
3/8 in. (67 cm).
6.
Tighten nut (4) and capscrew (5) on clamp (6).
7.
Install steering cylinder (WP 0141 00).
26 3/8"
(67 CM)
409-552
END OF WORK PACKAGE
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals