 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-1
WHEEL ASSEMBLY REPLACEMENT - CONTINUED
0134 00
INSTALLATION
NOTE
Repair of wheel assembly is limited to replacing valve stem and valve core (WP 0135 00).
Two personnel are required to position wheel assembly on wheel hub of vehicle.
1.
Place floor jack under appropriate axle housing, on
same side as wheel assembly (2) to be installed. Raise
vehicle as required until appropriate axle is off of jack
stand and wheel hub (6) is high enough for installation
of wheel assembly (2).
2.
Place wheel assembly (2) on wheel hub (6). Install but
do not tighten eight wheel nuts (5) until nuts are
2
seated.
3.
Remove jack stand from under axle.
4.
Lower vehicle with floor jack until tire (1) is just rest-
ing on ground.
6
5.
Torque wheel nuts (5) to 470 lb-ft (637 Nm).
6.
Completely lower vehicle with floor jack.
5
1
409-524
7.
Remove blocking material from between rear axle
housing (3) and both frame stops (4).
4
3
409-523
8.
Remove wheel chocks from tires (1) as required.
END OF WORK PACKAGE
0134 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals