REMOVAL - CONTINUED - TM-10-3930-660-24-10633

TM 10-3930-660-24-1

WHEEL ASSEMBLY REPLACEMENT - CONTINUED

0134 00

REMOVAL - CONTINUED

NOTE

For axle replacement, position floor jack under differential housing.

Place floor jack under appropriate axle housing, on same side as wheel assembly (2) to be removed. Raise vehicle until

tire (1) is off the ground.

NOTE

For axle replacement, position jack stand under frame to the inside of axle being removed.

Place jack stand under appropriate axle housing, on same side as wheel assembly (2) to be removed.

WARNING

Lifting equipment used for lifting vehicle must be in good condition and of suitable load capacity. Failure to

follow this warning may cause injury or death, or damage to equipment.

Two personnel are required to remove wheel assembly from wheel hub of vehicle. Failure to follow this

instruction could result in serious injury or death.

NOTE

Weight of wheel assembly is approximately 465 lb (211 kg).

Lower vehicle with floor jack until axle housing is

supported by jack stand.

Remove eight wheel nuts (5) and wheel assembly (2)

from wheel hub (6).

409-524

0134 00-3