BRAKE HYDRAULIC ACCUMULATOR MAINTENANCE

TM 10-3930-660-24-1

BRAKE HYDRAULIC ACCUMULATOR MAINTENANCE

0132 00

THIS WORK PACKAGE COVERS

Removal, Disassembly, Assembly, Installation, Testing

INITIAL SETUP

Materials/Parts - Continued

Tools and Special Tools

Soap, liquid (Item 52, WP 0323 00)

Tool kit, general mechanic's (Item 39, WP 0324 00)

Charging kit, pressure (Item 5, WP 0324 00)

Equipment Condition

Shop equipment, common no. 1 (Item 20, WP 0324

Machine parked on level ground (TM 10-3930-660-

10)

Wheels chocked

Materials/Parts

Cap and plug set (Item 8, WP 0323 00)

Oil, lubricating (Item 32, WP 0323 00)

REMOVAL

WARNING

Do NOT remove hydraulic tank filler cap or disconnect or remove any hydraulic system line or fitting

unless hydraulic system pressure has been relieved. Hydraulic system pressure can be over 3,000 psi

(20685 kPa), even with engine and pump OFF. To relieve pressure, lower all hydraulic attachments to

the ground and shut down engine. Move control levers through all operating positions, then SLOWLY

loosen hydraulic tank filler cap. After maintenance, tighten all connections before applying pressure.

Escaping hydraulic fluid under pressure can penetrate the skin, causing injury or death.

At operating temperature hydraulic oil is hot. Allow hydraulic oil to cool before disconnecting any

hydraulics. Failure to do so could result in injury.

CAUTION

Wipe area clean around all hydraulic connections to be opened during removal and disassembly. Cap oil

lines and plug holes after removing lines. Contamination of the hydraulic system could result in premature

failure.

NOTE

If more than one hydraulic line is to be removed, identify lines to ensure proper installation. Use container to

catch any hydraulic oil that may drain from system.