 |
|||
|
|
|||
|
Page Title:
ADJUSTMENT OF PARKING BRAKE CABLE |
|
||
| ||||||||||
|
|
 TM 10-3930-660-24-1
PARKING BRAKE LEVER AND CABLE MAINTENANCE - CONTINUED
0128 00
ADJUSTMENT OF PARKING BRAKE CABLE - CONTINUED
NOTE
If turning of knob cannot bring parking brake cable into adjustment, perform major adjustment as described
in steps 2 thru 8 of this procedure.
2.
Place lever (9) in the OFF position.
3.
Turn knob (28) on lever (9) so knob is approximately at middle of its full travel.
4.
Loosen jamnut (5) on cable (7).
5.
Tighten adjusting nut (6) on cable (7) approximately
two turns.
5
7
6
29
3
2
1
409-497
6.
Pull lever (9) to the ON position. It should take about 50 lb (23 kg) of pulling force to set parking brake.
7.
If necessary, repeat steps 2 thru 6 until a 50 lb (23 kg) pull on lever (9) is obtained.
8.
Tighten jamnut (5).
NOTE
If necessary, adjust clevis.
9.
Remove cotter pin (1) and clevis pin (2). Discard cotter pin.
10.
Loosen locknut (29). Turn clevis in or out as required. Tighten locknut.
11.
Install new cotter pin (1) and clevis pin (2).
12.
Place parking brake in on position and remove wheel chocks.
END OF WORK PACKAGE
0128 00-5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals