SERVICE BY DRAINING AND FILLING TRANSMISSION WITH OIL

TM 10-3930-660-24-1

TRANSMISSION ASSEMBLY MAINTENANCE - CONTINUED

0118 00

SERVICE BY DRAINING AND FILLING TRANSMISSION WITH OIL - CONTINUED

Replace transmission oil filter element (WP 0120 00).

Clean strainer (3). Install new gasket (4) and strainer. Securely tighten strainer.

NOTE

Transmission contains approximately 5 gal. (19 L) of oil when filled.

Remove cap of filler tube (5) and fill transmission (2) with 4 gal. (15 L) of oil.

Start and run engine (TM 10-3930-660-10) at idle speed with transmission travel select lever in neutral for two full min-

utes to allow transmission hydraulic system to charge.

NOTE

Full at 104F (40C) is the low mark (cold).

Full at 176F (80C)is the high mark (hot).

With engine still running at idle speed, check trans-

mission oil level of transmission (2) with dipstick (6).

If oil level is low, add additional oil until level reaches

full mark on dipstick.

Check for leaks at strainer (3), transmission oil filter

element, drain plug and at all transmission hose con-

nections.

409-4033

10.

Stop engine (TM 10-3930-660-10).

11.

Install transmission cover (WP 0150 00).

TESTING OF TRANSMISSION HYDRAULICS

Refer to STE/ICE-R Testing (WP 0008 00).

END OF WORK PACKAGE

0118 00-2