 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-1
JOYSTICK HARNESS ASSEMBLY MAINTENANCE - CONTINUED
0078 00
INSTALLATION
1.
If removed, connect joystick harness (6) to joystick (2).
CAUTION
Connect all leads as described in steps 2 through 4. Refer to figure below as necessary. Failure to properly
connect leads may result in serious damage to joystick or electrical system.
2.
Connect leads 52, 51 and 2 (A) to top terminal strip of joystick (2).
3.
Connect leads 54, 2, 50 and 53 (B) to middle terminal strip of joystick (2).
4.
Connect leads 56, 2, 50 and 55 (C) to bottom terminal strip of joystick (2).
5.
If removed, secure joystick (2) to cover plate (1).
6.
Position joystick (2) so that wide side of cover plate (1) is on same side as electrical terminals of joystick.
NOTE
Apply loctite to threads of screws.
7.
Secure joystick (2) and gasket (19) to cover plate (1) with four new nylon washers (11) and four screws (10).
8.
Install and tighten hose clamp (9).
9.
Install cover plate (1) and joystick (2) as an assembly to the side console (3).
10.
Support joystick (2) and cover plate (1) as an assem-
4
1
bly over side console (3).
11.
Plug male plug (5) of joystick harness (6) into female
2
plug (7) of vehicle wiring harness (8).
6
5 7
NOTE
8
Make sure wide side of cover plate faces driver.
12.
Position cover plate (1) and joystick (2) as an assem-
bly into side console (3).
NOTE
Apply loctite to threads of capscrews.
3
13.
Install four capscrews (4) to secure cover plate (1) to
409-289
side console (3).
14.
Connect battery cables (WP 0107 00).
0078 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals