Table 1. Unit Preventive Maintenance Checks and Services (PMCS) for 6K Forklift - Continued.

TM 10-3930-660-24-1

UNIT PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) - CONTINUED

0011 00

Table 1. Unit Preventive Maintenance Checks and Services (PMCS) for 6K Forklift - Continued.

Location

Item To

Man-

Check/

Hours

Item No.

Interval

Procedure

Service

a. Inspect for cracked weld, bends, breaks, chipped/missing paint or corro-

Semi-

ROPS/

sion. Do NOT attempt to straighten ROPS/FOPS if damaged.

annual

FOPS

b. Check for loose or missing mounting bolts, washers, and nuts. Install

new mounting hardware or tighten as required. Apply torque of 375 lb-ft

(508 Nm).

Seat Belts a. Inspect seat belt for security of mounting, worn or frayed strap webbing

Semi-

or worn or damaged buckle and anticreep slides. Replace seat belt if

annual

damaged (WP 0161 00).

NOTE

Date label attached to seat belt indicates age of belt.

b. Replace seat belt, regardless of condition, if it has been in service for

three years (WP 0161 00).

Annual

Drain

Fuel

WARNING

DO NOT perform fuel system checks, inspections or maintenance

while smoking or near fire, flames or sparks. Fuel may ignite,

causing damage to vehicle and injury or death to personnel.

Operating personnel must wear fuel-resistant gloves when han-

dling fuels. If exposed to fuel, promptly wash exposed skin and

change fuel-soaked clothing.

NOTE

Forklift should be parked on level ground with transmission in

Neutral (N) and locked and parking brake applied. Shut down

engine.

Fuel capacity of fuel/hydraulic tank is 44 gal. (167 L) when full.

a. Remove fuel tank filler cap.

b. Place suitable container under fuel side of fuel/hydraulic tank.

c. Remove drain plug from bottom of fuel/hydraulic tank and allow fuel

and accumulated water and sediment to drain from tank.

d. Clean drain plug and reinstall.

e. Fill fuel tank with diesel fuel (Item 28 or 29, WP 0323 00).

0011 00-10