 |
|||
|
|
|||
|
Page Title:
REASSEMBLY OF STEER AXLE COMPONENTS. |
|
||
| ||||||||||
|
|
 B.
Spider
Spider
B.
Remove snap ring from
Step 1.
Step 1.
Install new bearings
top of spider and remove shim(s)
and seals into the spider and
then pull spider up and off from
install spider onto the steer
the steer axle pin.
axle pin.
Remove seal and bearings
Step 2.
Step 2.
Install washer then
from spider housing.
snapring onto the steer axle
pin.
Measure distance be-
5-186.
REASSEMBLY OF STEER AXLE COMPONENTS.
tween washer and snap ring,
if distance exceeds .015 re-
A.
Knuckle
move snap ring and add shim(s)
128517.
Install new bushings from
Step 1.
knuckle pin kit into steer axle.
Step 3.
Install tie rod end
into the spider and install tie
Step 2.
Hold knuckle in place and
rod nut and torque to 68-82
position new thrust bearing on top
ft. lbs. then turn nut to next
of knuckle.
cotter slot and install cotter
pin.
Align holes in steer axle
Step 3.
knuckle pin from the top of steer
STEER AXLE INSTALLATION
5-187.
axle.
a.
Before installing steer axle
Pull up on knuckle and
Step 4.
inspect both silent blocks for any
measure the distance between
deflection, if radial deflection ex-
bottom of knuckle and top of steer
ceeds .050 or axial deflection exceed
axle lower knuckle housing. If
.500 replace the silent blocks.
this distance exceeds .022" knuckle
pin must be removed and add one
To replace the silent blocks
b.
shim (part number of shim is 100194)
proceed as follows:
between bottom of knuckle and top
of lower steer axle knuckle housing.
Remove cotter pin from
Step 1.
nut and remove nut.
Step 5.
Align notch in knuckle pin
with hole in knuckle and install new
Step 2.
Remove silent block
lock pin from front side of axle and
and discard.
tap into place with drift and hammer.
Step 3.
Install new silent
Step 6.
Install new upper & lower
block and install nut and
expansion plugs into the steer axle
torque to 210-260 ft. lbs.
knuckle housings.
Tap on center of
install cotter pin.
expansion plug until it flattens and
locks into housing.
Roll steer axle under the
C.
machine to its approximate position
Install the tie rod end into
Step 7.
for mounting.
the knuckle and install the nut and
torque to 68-82 -Et. lbs. then turn
Position floor jack in center
d.
nut to next cotter slot and install
of steer axle and raise floor jack
cotter pin.
and at the same time aligning the
steer axle to its mounting position.
Install steer wheel and
Step 8.
tire assembly to the steer axle.
5-211
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals