 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 5-161 SIDE SHIFT CYLINDER
Remove the "O"-Ring and back-up
g.
ring from the Gland and Piston (Items
5-162 REMOVAL
3 and 4 in fig. 6-9).
Remove the wiper and gland packing
h.
a.
Release the fork latches and remove
from Gland (Items 5 and 6 in fig. 6-9).
the forks.
Install new packing and wiper into
Remove the hydraulic line tie strap
1.
b.
Gland.
and remove the hydraulic lines (items 1
and 2 in fig. 6-8) away from the fit-
Install new "O"-Ring and back-up
tings in the cylinder.
j.
CAUTION:
ring on Gland and Piston.
On Gland install Back-Up ring first
Remove the cylinder anchor end nut
C.
then "O"-Ring, o n P i s t o n i n s t a l l
(item 5 in fig. 6-8).
"O"-Ring them Back-Up ring.
Remove the two cylinder rod end pin
d.
Install Piston Assembly into barrel.
k.
retainers and the one rod end pin (Items
Make sure Piston Rod Assembly
CAUTION:
6 and 7 in fig. 6-8).
is free of all foreign material.
Remove the cylinder (items 8 in fig.
e.
Install Gland into Barrel and
1.
6-8) from the carriage.
tighten.
5-163 REPAIR
5 - 1 6 4 INSTALLATION
Should it be found the side shift cylin-
Refer to figure 6-8.
der is leaking, the cylinder packing
a.
must be replaced.
Install new "O"-Rings onto the
b.
fittings and install the fittings
Remove the side shift cylinder as
a.
into the Side Shift Cylinder.
described in Section 5-162.
Install base end of cylinder in
C.
Place the cylinder in a vise or
b.
truck carriage cylinder anchor.
other suitable clamping device.
Install rod end of cylinder in fork
bar cylinder anchor.
Refer to figure 6-9 for detailed
C.
parts identification and proceed as
Secure rod end with pin and
d.
follows.
Secure base end with
cotter pins.
nut.
(Tighten nut snug then turn
Remove the cylinder gland (Item 1
d.
back 1/2 turn).
in fig. 6-9).
Connect the hydraulic hoses to
e.
Remove the piston rod assembly (Item
e.
To remove the piston rod
the fittings in the cylinder and
2 in fig. 6-9).
secure the hoses with the tie straps.
assembly, grab with hand and pull the
assembly out away from the barrel.
f. Install the forks and latch them.
Inspect the piston rod for damage
f.
Polish the
or nicked chrome finish.
rod until the surface is smooth; if
damage is deep, replace the rod.
5-198
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals