 |
|||
|
|
|||
|
Page Title:
INPUT SHAFT ASSEMBLY - continued |
|
||
| ||||||||||
|
|
 Step 43. Plate 10361
STEP 43. Measure the output shaft oil distri-
butor sleeve seals.
Seals must be replaced if a MAXIMUM of .008"
Step 44. Plate 10362
and above measurement is obtained.
STEP 4. Assemble the auxiliary drive gear into
transmission with hub of gear facing the con-
verter end.
STEP 45. Using clutch install tool, place clutch
STEP 46. Carefully install clutch pack into
pack assembly Into transmission with small gear
down and tilt to one side, install spacer with
position on spacer making sure spacer does not
beveled end toward auxiliary gear.
move out of position.
Step 46. Plate 10364
Step 45. Plate 10363
5-80AB
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals