REASSEMBLY - TM-10-3930-644-14-P0330

TM 10-3930-644-14&P

2. Inspect all parts for cracks, breaks, bends, other

Type II and III Steer Axles:

damage, and wear. Repair or replace parts as

indicated by their condition.

Install retaining ring and lower bearing cup in

steer axle housing; install upper bearing cup.

3. Lubricate all parts except the ball sockets with

Make certain cups are firmly seated. Install seal

an SAE 10 or 20 oil. Pack the tie rod ball

and cone on pivot arm pin; install pivot arm,

sockets with nigh quality chassis lube.

lower cone, seal, washer, and new nut. (For

proper installation procedure, refer to following

D. REASSEMBLY

Paragraph F, PIVOT ARM INSTALLATION

PROCEDURE.)

1. Type I Steer Axle:

2. Install king pin needle bearings in the axle

Install bushings in axle. Position spacers and

assembly. Position the spindle on the axle and

pivot arm on axle assembly and insert the pivot

insert the king pin. Align the roll pin in the king

pin. Align the groove in pin with wedge bolt slat,

pin and spindle, and insert the roll pin. Install

insert wedge bolt (Fig. 3), and secure with

and stake new expansion plugs.

washer and nut.

3. Assemble the nut, ball socket, cup,

3-160