 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-644-14&P
f. To replace spindle, align the spindle in the
directions, then back nut off 30 minimum
drive housing and replace the washer and
to 60 maximum so cotter pin can be
locknut. Tighten the nut until the spindle
installed.
fully seats, then Install the cotter pin.
TORQUE VALUES:
g. install the dust shield and the wheel
assembly.
ALL MODELS .............................120 lb/ft
h. Tighten wheel bearing nuts as follows:
Using a torque wrench, tighten nuts in
accordance with chart below; just before
reaching maximum torque, turn each
wheel six times La both
3-141
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals