|
|
TM 10-3930-644-14&P
B. REASSEMBLY
verter housing. Use a new gasket and ensure
that holes are properly aligned.
NOTE
Converter:
The converter flex plate was marked
before transmission removal to show
relationship with engine flywheel.
CAUTION
Marks must be aligned when flex
Ensure
that
the
transmission
plate is installed.
mounting area is free and clear of
any obstacles, such as linkage and
Pump:
hoses to prevent damage.
1. Install new seal rings and new oil seal.
1. Position the converter in the pump at the back of
the transmission, making sure that the converter
2. Lubricate all parts with light engine oil.
hub tangs properly engage pump driven gear.
3. Install the pump on the stator support making
2. Refer to TOPIC 1 TRANSMISSION, Paragraph
sure holes are properly aligned. See Figure 2-1.
G, INSTALLATION and install transmission and
torque converter on engine following the
4. The pump can now be installed on the con-
instructions in that paragraph.
R-171-1
3-126
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |