|
|
TM 10-3930-644-14&P
to pump. If contamination of hydraulic oil is
32. Fill radiator to capacity with water.
Add anti-
suspected, drain reservoir, change filter and
freeze if required.
replace oil, after filtering oil through a 10 micron,
or finer, filter.
33. Fill crankcase with 4.5 quarts of recommended
engine oil. Check oil level stick for full reading.
26. Install radiator, taking care not to damage
cooling fins, and replace upper and lower
NOTE
radiator hoses, thermostat and hose clamps.
Ensure that all hoses, electrical lines
and mechanical linkages have been
27. Connect
transmission
oil
cooling
lines
to
completed. Be sure all capscrews,
radiator.
braces and mounts are secure.
28. Replace counterweight and secure capscrews.
34. Check fuel tank for water condensation: drain if
necessary.
CAUTION
35. Fill tank to recommended limit with proper
Use extreme care when replacing
octane gas and open fuel cutoff valve.
counterweight to prevent personal
injury or damage to equipment.
36. Start engine, run at Idle for approximately 5
29. Replace grille and secure.
minutes, then shut off and check radiator water
level, crankcase dipstick and transmission oil
30. Replace angle braces, seat plate, engine cover
level stick for full capacities.
and side panels, and seat. Replace floor and
toe plate.
37. Check for evidence of oil, fuel or water leaks.
31. Install battery tray and battery. Connect any
38. Continue with
engine
run-in
schedule
as
wiring removed from tray attachment and
specified.
connect battery terminal leads.
3-52
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |