INSPECTION - TM-10-3930-644-14-P0216

TM 10-3930-644-14&P

30. Once free of the frame, lower engine onto

11. Remove transmission oil level stick and fill with

engine support and after proper seating and

specified transmission oil to full mark, as

weight support is ascertained, remove hoisting

indicated on oil level stick.

chain.

CAUTION

31. With transmission properly supported by

Do not over-fill transmission.

attaching hoist chain, remove securing

capscrews and carefully disengage transmission

assembly from engine.

12. Replace oil pan drain plug, and close coolant

drain cock at radiator and cylinder block.

B. INSPECTION

13. Replace oil filter cartridge and connect oil filter

Look engine over closely for any signs of damage, wear

lines to engine as labeled and connect oil filter

or evidence of leaks. Necessary action should be taken

lines to engine as labeled.

to correct any abnormal conditions.

C. INSTALLATION

14. Connect accelerator linkage and choke control

at carburetor.

1. Ensure that engine is free of rags, tools, extra

parts, excess water, oil, fuel cleaning agents.

15. Connect fuel line to fuel strainer.

2. Make certain that any maintenance perform ed

16. Install exhaust pipe and attaching clamps and

was properly done and that nuts and capscrews

are all torqued to specification.

hardware.

3. Refer to REPAIR MANUAL TRANSMISSION

17. Verify proper electrode gap, .025", and install

and install transmission on engine.

spark plugs. Torque plugs 25-30 lbs. ft.

4. Properly attach hoisting chain to engine and

18. Replace distributor cap with attaching ignition

transmission lifting eyes and take up slack in

chain.

wires. Remove labeling tape as ignition coil and

spark plug wires are properly affixed.

CAUTION

Be certain that frame, engine and

19. Connect temperature sender and oil pressure

transmission mounting areas are

sender wires.

Connect neutral start switch

clear of any obstructions such as

wires.

wiring, hoses, mechanical linkage,

etc., prior to installation.

20. Install alternator and mounting hardware but do

5. Carefully maneuver engine assembly into

not lock adjusting brace at this time. Connect

mounting position and slowly, guarding against

associated alternator wiring.

any binding, lower assembly onto engine

mounts.

21. Inspect belt for wear, replace if necessary, and

mount on fan drive pulley, water pump and

6. Install and secure mounting bolts. Torque to 20

alternator pulleys.

lbs. ft.

7. Disengage hoisting chain and clear from work

22. Secure alternator adjusting brace for fan belt

area.

depression of /4" - /2" with 10 lbs. of pressure

applied.

8. Refer to REPAIR MANUAL UNIVERSAL

JOINTS AND COUPLINGS and connect

23. Install air cleaner and attaching hardware, hoses

universal joint to transmission.

and clamps.

Inspect filter element for

9. Refer to REPAIR MANUAL TRANSMISSION

contamination and replace if necessary.

and connect transmission linkage and cooling

lines. Install transmission drain plug.

24. Replace fan blade and secure capscrews.

10. Connect transmission oil filter lines and inspect

25. Install hydraulic pump sleeve and gear and

filter

for

contamination

scheduled

install pump.

Connect hydraulic lines

replacement. Change if required.

3-51