 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-638-24&P
4-5. AXLE MAINTENANCE (cont)
b. Differential Case and Gear Assembly (cont).
REMARKS
ACTION
ITEM
LOCATION
STEP
DISASSEMBLY
Mark
Use punch or chisel to mark for correct
a. Case halves (3
1
Differential
alignment during reassembly
and 4)
case and gear
Remove
assembly
b. Eight cap screws (1)
and washers (2)
Separate
c. Differential case plain
half (3), and flange
half (4)
Remove
d. Thrust washer (5)
e. Side gear (6)
Remove
f. Four thrust washers
Remove
(7)
g. Four pinion gears (8)
Remove
h. Spider (9)
Remove
Remove
i. Side gear (10)
Remove
j. Thrust washer (11)
NOTE
If rivets (15) are used to secure ring gear (16) and differential case
flange half (4), proceed to step b below; otherwise perform step a
and disregard step b.
2
a. 12 cap screws (12),
Remove
Differential
washers (13),
case flange
and nuts (14)
half (4)
Drill out
Center punch rivets in center of head, Use
b. 12 rivets (15)
drill bit 1/32 inch smaller than body of
rivet and drill through head. Carefully
press out rivets
c. Ring gear (16)
Remove
Use puller
d. Bearing cone (17)
Remove
3
Differential
Bearing cone (18)
Remove
Use puller
case plain
half (3)
4-248
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals