DISASSEMBLY - TM-10-3930-638-24-P0967

TM 10-3930-638-24&P

4-4.

TRANSMISSION

MAINTENANCE

(cont)

e. Transmission Housing (cont).

REMARKS

ITEM

ACTION

LOCATION

STEP

DISASSEMBLY (cent)

a. Two cap screws (14)

Remove

Transmission

Remove

b. Two lock washers (15)

housing (34)

c. Cap screw (16)

Remove

d. Lock washer (17)

e. Suction tube assem-

Withdraw

From transmission housing

bly (18)

f. O-ring(19)

Remove and

discard

g. Suction tube

Remove

clip (20)

NOTE

To drill out tube ends, use drill bit with same diameter of tubes

at sleeves.

h. Low speed clutch

Remove and

Drill out tube ends at points V and X

pressure tube

discard

(21)

i. O-rings (22

Remove and

and 24)

discard

j. Tube sleeves (23

Remove and

and 25)

discard

k. Third speed tube

Drill out tube ends at points U and W

Remove

(26)

l. O-rings (27

Remove and

and 29)

discard

m. Tube sleeves

Remove and

(28 and 30)

discard

n. Lubrication clutch

Remove

DriIl out tube end at point Z

tube (31)

o. O-ring (32)

Remove and

discard

p. Tube sleeve (33)

Remove and

discard

CLEANING

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable.

Wear protective goggles and gloves and use only in a well ventilated area.

Avoid contact with skin, eyes, and clothes and don't breathe vapors. Do not

use near open flame or excessive heat and don't smoke when using it. Failure

to do so could cause serious injury. If you become dizzy while using cleaning

solvent, get fresh air immediately, and get medical attention. If contact with

skin or clothes is made, flush with large amounts of water. If contact with eyes

is made, wash eyes with water immediately, and obtain medical aid immediately.

4-189