 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-638-24&P
4-4. TRANSMISSION MAINTENANCE (cont)
c. Transmission Rear Cover (cont).
REMARKS
ITEM
ACTION
LOCATION
STEP
INSTALLATION (cont)
a. shift rail oil seal (24) Install and
36
High and low
Apply thin coat of Permatex 2 on
lubricate
shift rail
outer diameter of oil seal then press
support (23)
into support with lip of oil seal
toward rear cover. Lubricate oil seal
with OE10 (refer to current
lubrication order)
b. O-ring (25)
Lubricate and
Lubricate with GAA (refer to current
install
lubrication order); position on shift
rail support (23)
a. Mesh lock spring (20) Install
Rear Cover
37
Apply GAA grease to mesh lock
(29)
spring and ball (19) before installing
b. Mesh lock ball (19)
Install
Install
c. High and low shift
Place small diameter long screw
rail support (23)
through high and low shift rail
support (23) to hold ball (19) in
depressed position, against spring
(20). Place high and low shift rail
support (23) on high and low shift
rail with screw upward, until
flat of shift rail catches ball (19).
Then remove small diameter long
screw from support (23). Push high
and low shift rail support (23) while
also turning it, until support is
against rear cover (29)
d. Two lock washers
Install
Tighten to 41-45 pounds foot torque
(22) and nuts (21)
e. Detent plug (18)
Install
38
a. Rear bearing cap
Install and
Output shalt
Apply thin coat of Permatex 2 on
oil seal (17)
lubricate
bearing cap
outer diameter of oil seal then press into
(13)
bearing cap with lip of seal toward bear-
ing side of cap. Lubricate oil seal with
OE10 (refer to current lubrication
order)
Lubricate with OE10 (refer to
Lubricate and
b. O-rings (14 and
current lubrication order);
position
15)
posit ion on bearing cap(13)
Position
On output shaft
a. Bearing to flange
Rear cover
39
spacer (16)
(29)
Position
b. Output shaft bear-
ing cap (13)
Change 1
4-167
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals