 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-638-24&P
4-4. TRANSMISSION MAINTENANCE (cont)
c. Transmission Rear Cover (cont).
REMARKS
ITEM
ACTION
LOCATION
STEP
INSPECTION (cont)
Mesh lock spring (20)
Inspect
Replace if cracked, broken, deformed or
34
permanently set
INSTALLATION
a. Rear cover to case
Position
Transmission
35
Install two aligning studs in
housing, rear
gasket (30)
transmission housing to facilitate
positioning of gasket and installation
of rear cover (29). Apply thin coat of
GAA to hold gasket in place.
NOTE
Before performing next step, move forward range shift hub on
output shaft (see below). Pulling on high and low shift rail may
cause hub to fall off.
Position
Tap rear cover in place aligning shaft bear-
b. Rear cover (29)
ings with bearing bores in cover
Remove two aligning studs after
c. 20 lock washers
Install
several lock washers and cap screws
(28) and cap
are installed; tighten cap screws to
screws (27)
37-41 pounds foot torque
InstalI
d. Locating rings (35)
4-166
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals