CLEANING - TM-10-3930-638-24-P0935

TM 10-3930-638-24&P

4-4.

TRANSMISSION

MAINTENANCE

(cont)

b. Converter Housing (cont)

STEP

LOCATION

ITEM

ACTION

REMARKS

CLEANING

Use cleaning solvent P-D-680. Immerse

All parts except bear-

Clean

parts and move up and down slowly

ings (4, 6, 12, and 16),

until all lubricant and foreign material

converter housing (32)

is dissolved. Dry parts thoroughly after

and switch (20)

removal from cleaning solvent with mois-

ture free compressed air or clean cloths

Use cleaning solvent P-D-680. Immerse

Clean

hearings (4, 6, 12,

bearings and slowly move up and down.

and 16)

Remove bearings from cleaning solvent

and strike larger side of cone flat against

a block of wood to dislodge solidified

particles of lubricant, Immerse again in

cleaning solvent and repeat above proce-

dure until bearings are thoroughly clean.

Dry bearings using moisture free compress-

ed air. Be sure you direct air stream

across bearing to avoid spinning. Don't

spin bearing when drying them; bearings

may be rotated slowly by hand to faci-

litate drying

WARNING

Exercise care when using alkali cleaners to avoid coming in contact

with cleaner or breathing vapors to prevent skin rashes and bodily

harm. Wear a rubber apron to prevent clothes from coming in con-

tact with cleaner and use cleaner in a well ventilated area. If alkali

cleaner is splashed on clothes or skin, flood area with large amounts

of water and get immediate medical attention.

Clean exterior and interior thoroughly

Converter housing (32)

Clean

with cleaning solvent P-D-680, or clean

in hot solution tank with mild alkali

solution. Part must remain in solution

long enough to be thoroughly cleaned

and heated. Rinse with clean water to

remove all traces of alkali. Cast portions

may be steam cleaned. Thoroughly dry

immediately using moisture free com-

pressed air or clean cloths

Transmission tempera-

Clean

Clean exterior of switch with clean cloth

moistened with cleaning solvent; dry

ture switch (20)

using clean cloth

4-157