REASSEMBLY (cont) - TM-10-3930-638-24-P0905

TM 10-3930-638-24&P

4-3. FUEL SYSTEM MAINTENANCE (cont)

b. Fuel Injection Pump (cont).

REMARKS

ITEM

ACTION

STEP

LOCATION

REASSEMBLY (cont)

Install

Back-out low idle screw (41 ) and push

b. Governor control

cover (22)

throttle lever (36) into shutoff position.

(cont)

Move cover (22) down toward pump in a

position further toward drive shaft end

than normal. Just before cover (22)

touches housing, slide cover into align-

ment with housing

c. TWO lock

Position

washers (16 and 17)

Position

d. Grounding strap (15)

e. Three washers (12),

Install

Tighten to 3545 pounds inch torque

lock washers (11)

and screws (1 O)

f. Washer ( 14) and

Install

two nuts (13)

g. Connector (21)

Install

Tighten to 200 pounds inch torque

Wire in wide

h. Throttle shaft

open position

assembly (37)

i. Drive shaft (5)

Remove

j. Pilot tube seal (8)

Install

Drive

Roll pin (7)

shaft (5)

NOTE

Place two new seals (6), drive shaft (5), lock washer (4), nut (3),

spring (2), and thrust plunger ( 1 ) in a small cloth bag; these parts

will be assembled when fuel injection pump is installed. Attach

bag to fuel injection pump securely.

Housing, sides

a. Two gaskets (126)

Position

b. Two timing line

covers (125)

c. Four screws (1 24)

Install

Tighten to 15-20 pounds inch torque

Install

d. Eight washers

(113) and four

fuel line

connector screws

(112)

Tighten

To 360 pounds inch torque

e. Two head

locking screws

(63)

4-127