 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-638-24&P
4-3. FUEL SYSTEM MAINTENANCE (cont)
b. Fuel Injection Pump (cont).
REMARKS
ACTION
ITEM
LOCATION
STEP
REASSEMBLY (cont)
b. Screw (30)
Install
(cont)
c. Spring retainer (26)
Install
On screw (25)
Position
d. Throttle lever
On screw (25)
spring (27)
Position
e. Spacer adjusting
On spacer, in recess
arm (29)
f. Throttle lever
Position
On spacer adjusting arm (29)
assembly (28)
Install
g. Screw (25), spring
Finger tight
retainer (26), and
throttle lever
spring (27)
Position; cross ends
h. Throttle lever
over each other
spring (27)
to clamp throttle
lever (28) and arm
(29) together
Tighten
i. Screw (25)
To 35-40 pounds inch torque
Governor
34
a. Solenoid frame
Position
On governor control cover (22)
control
and arm
cover (22)
assembly (24)
Install
b. Two insulating
washers (20)
and washers (19)
c. Two nuts(18)
Install
Tighten to 20-25 pounds inch torque
Housing,
35
Position
a. Gasket (23)
top
CAUTION
Exercise extreme care in the following step when installing
governor control cover. It is possible to locate solenoid shutoff
arm on the wrong side of linkage hook (54) tab, thus locking
linkage hook in full run position, blocking all governor action.
If this condition exists, engine may accelerate to dangerously high
speeds when started.
4-126
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals