REMOVAL - TM-10-3930-638-24-P0735

TM 10-3930-638-24&P

3-30. HYDRAULIC LIFT SYSTEM MAINTENANCE (cont)

c. Sideshift Clinder Assembly (cont).

ITEM

REMARKS

LOCATION

ACTION

STEP

REMOVAL (cont)

CAUTION

Support sideshift cylinder assembly while performing following

step to prevent it from falling.

e. Two cap screws (8)

Remove

and lock washers (9)

f. Cylinder mounting

Remove

strap (10)

g. Sideshift cylinder

Remove by pulling

out from side of

assembly (11)

carriage assembly

DISASSEMBLY

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open flame or exces-

sive heat and don't smoke when using it. Failure to do so could

cause serious injury. If you become dizzy while using cleaning

solvent, get fresh air immediately, and get medical attention. If

contact with skin or clothes is made, flush with large amounts of

water. If contact with eyes is made, wash eyes with water immedi-

ately, and obtain medical aid immediately.

Sideshift

a. Sideshift cylinder

Clean all exterior

Use cleaning solvent P-D-680

cylinder

assembly (11)

surfaces

assembly (11)

b. Gland assembly (19)

Loosen

c. Rod (26), gland as-

Remove as an

sembly (19), and

assembly

piston assembly (14)

Remove

d. Cap screw (12) and

washer (13)

e. Piston assembly (14)

Remove

f. Gland assembly (19)

Remove

Piston

a. Two wear rings(15)

Remove and

assembly (14)

discard

b. Seal (16)

Remove

c. Seal loader ring (17)

Remove and

discard

3-227