CLEANING - TM-10-3930-638-24-P0701

TM 10-3930-638-24&P

3-27. SEPARATION OF FRONT AND REAR CHASSIS (cont)

STEP

ITEM

ACTION

LOCATION

REMARKS

CLEANING (cont)

WARNING

(cont)

Wear safety glasses when drying parts with compressed air. Failure

to do so could cause serious injury to eyes and possible blindness.

If you hurt your eyes or if a foreign object is blown into your eyes,

seek medical attention immediately.

All other parts

Clean

Use cleaning solvent P-D-680. Dry

thoroughly with moisture free com-

pressed air

INSPECTION

Inspect

Replace if cracked, worn or deteriorated

Two pivot bearings (7)

Inspect

All other parts

Replace if worn, or if threads damaged

INSTALLATION

a. Two grease fittings (9)

Install and tighten Until securely mounted, with fitting

Rear chassis

inlet facing left or right side of vehicle

Install

Press into lower pivot bearing (7)

b. Pivot bushing (8)

c. Two pivot bearings (7)

Install

Press into pivot bores in rear chassis

Position

Push against rear chassis until upper and

Front chassis

lower pivot bores are aligned

Rear chassis

a. Upper pivot pin (2)

Install

If necessary, gently tap into bearing (7)

using hammer

b. Retaining ring (1)

Install

Use snap ring pliers

Install

If necessary, gently tap into bushing (8)

c. Lower pivot pin (6),

using hammer

with washer (4), and

spacer (5)

d. Spacer (5), washer (4),

Install and tighten Tighten lock nut (3) and lower pivot pin

(6) to 340-360 pounds foot torque

and lock nut (3)

3-193