REMOVAL - TM-10-3930-638-24-P0700

TM 10-3930-638-24&P

3-27. SEPARATION OF FRONT AND REAR CHASSIS (cont)

REMARKS

ACTION

ITEM

STEP

LOCATION

REMOVAL

Use hoist or other lifting device attached to

Support

Front chassis

Front

ROPS side supports to prevent front

chassis

chassis from tipping when pulled from

rear chassis

Block

To prevent rear chassis from moving or

a. Wheels and frame

Rear chassis

tipping when front chassis is removed

Use snap ring pliers

b. Retaining ring (1)

Remove

Lift and remove

If necessary, tap bottom of pivot pin using

c. Upper pivot pin (2)

drift and hammer

WARNING

Front chassis and rear chassis are extremely heavy. Do not pro-

ceed unless chassis are secured to prevent movement and tipping.

Failure to do so could cause serious injury or death.

If necessary, tap top of pivot pin using

d. Lock nut (3), two

Loosen and

drift and hammer

remove

washers (4), two

spacers (5), and

lower pivot pin (6)

Pull from rear chassis

Front chassis

Remove

Front chassis

a. Two pivot bearings (7)

Remove

Rear chassis

From lower pivot bearing (7)

b. Pivot bushing (8)

Remove

If necessary for replacement

Loosen and

c. Two grease fittings (9)

remove

CLEANING

Wipe with clean cloth only

Clean

Two pivot bearings (7)

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open flame or exces-

sive heat and don't smoke when using it. Failure to do so could

cause serious injury. If you become dizzy while using cleaning

solvent, get fresh air immediately, and get medical attention. If

contact with skin or clothes is made, flush with large amounts of

water. If contact with eyes is made, wash eyes with water immedi-

ately, and obtain medical aid immediately.

3-192