 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-638-24&P
3-13. STARTER AND SOLENOID REPAIR (cont)
REMARKS
ACTION
STEP
REASSEMBLY (cont)
Position
e. Connector (2)
f. Lock washer (48)
Install and
(cont)
tighten
and screw (47)
NOTE
Always replace brushes and springs as a set.
19
a. Two brushes (39)
Install
Brush holder
(37, 38)
b. Four screws (40 and
Install and
41)
tighten
c. Two brush springs
Install
Assemble with holders (37, 38)
(35)
20
Field frame (7)
a. Two control assem-
Position
blies (46)
b. Four screws (43)
c. Four lock washers
Install
(45)
Install
d. Four nuts (44)
e. Two brush support
Install
pins (36)
f. Two brush holder
Position
Place in control assembly (46). Push
assemblies
and install
holders and spring to bottom of control
(37, 38)
assembly and rotate spring to engage the
slot in the assembly
g. Two ground brush
Connect
leads (42)
a. Sleeve bearing (21)
21
Center bear-
Install
If removed
ing (20)
b. Oil seal (19)
Install
c. Gasket (18)
Install
22
a. Center bearing as-
Armature
Install
(10)
sembly (17)
b. Washer (16)
Install
c. Drive assembly ( 15)
Lubricate and
Apply light coat &lubricant to drive end
and armature (10)
position
of armature shaft. Slide drive assembly
shaft
onto shaft with pinion away from
armature
d. Stop collar (13)
Position
Face cupped surface of collar away from
armature
e. Armature (10)
Position
Stand on a wood block with commutator
down
f. Retaining ring (14)
Install
Tap into place with small block of wood
and a hammer
3-110
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals